Calling Name Presentation through PRI-circuit to CUCM
Hello! I have a problem with sending Calling name through E1 circuit from Siemens Hipath.
I have a follow configuration:Siemens HiPath1----E1 qsig---->cisco c2901----mgcp--->CUCM---mgcp--->cisco c2901---e1 qsig--->Siemens HiPath2
When I call from the Siemens HiPath1to the Siemens HiPath2 through this chain of devices,I don't see calling name on the display. When I call from the Siemens HiPathto IP-phone registered on the CUCM, calling name is being presented properly. Is it supported configuration, when calling name is being sended through CUCM to another PBX?
"Calling Name Presentation" at all patterns are set to "Allowed".CUCM, Gateways
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...
CUCM can backup the manually or have sehchduler to backup the configuration and historical reports from the server diester recovery systemStep 1. Navigate to CUCM > Disaster Recovery System > Backup > Manual Backup as shown in the...