Hello!
I have a problem with sending Calling name through E1 circuit from Siemens Hipath.
I have a follow configuration: Siemens HiPath1 ----E1 qsig---->cisco c2901----mgcp--->CUCM---mgcp--->cisco c2901---e1 qsig--->Siemens HiPath2
When I call from the Siemens HiPath1 to the Siemens HiPath2 through this chain of devices, I don't see calling name on the display. When I call from the Siemens HiPath to IP-phone registered on the CUCM, calling name is being presented properly. Is it supported configuration, when calling name is being sended through CUCM to another PBX?
"Calling Name Presentation" at all patterns are set to "Allowed".CUCM, Gateways
