07-17-2002 05:34 AM - edited 03-12-2019 07:57 PM
I have yet to get Call Manager to load on our new DL 380 G2. It starts to load the OS after asking for Disk 4 , then I get a message Moving past Cylinder 1023 may make the partition unbootable. If you continue it does make the patition unbootable. Is there an updated image for the new DL 380s ?
07-17-2002 05:50 AM
Have you run the Compaq system erase utility prior to loading the CM software? I've found that in more than one occasion this has cleaned out artifacts from the system that allowed CM to load. Hope this helps.
C.
07-17-2002 06:27 AM
what version of Callmanager? The G2 needs at least Callmanager 3.13a to be able to boot. CCM 3.13a has image for DL380 G2. Any version prior to that does not. I ran into the same situation with CCM 3.12. 3.13a did the trick.
07-17-2002 06:59 AM
Where can I find this image ? Is ti downloadable ?
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide