cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
162
Views
0
Helpful
3
Replies
Highlighted
Beginner

Callmanager on Compaq DL 380 G2

I have yet to get Call Manager to load on our new DL 380 G2. It starts to load the OS after asking for Disk 4 , then I get a message Moving past Cylinder 1023 may make the partition unbootable. If you continue it does make the patition unbootable. Is there an updated image for the new DL 380s ?

3 REPLIES 3
Highlighted
Beginner

Re: Callmanager on Compaq DL 380 G2

Have you run the Compaq system erase utility prior to loading the CM software? I've found that in more than one occasion this has cleaned out artifacts from the system that allowed CM to load. Hope this helps.

C.

Highlighted
Beginner

Re: Callmanager on Compaq DL 380 G2

what version of Callmanager? The G2 needs at least Callmanager 3.13a to be able to boot. CCM 3.13a has image for DL380 G2. Any version prior to that does not. I ran into the same situation with CCM 3.12. 3.13a did the trick.

Highlighted
Beginner

Re: Callmanager on Compaq DL 380 G2

Where can I find this image ? Is ti downloadable ?

Thanks

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey