Can I use two touch 10 with SX/MX endpoints?

[hxmengmetro]

Hi All,

In Cisco's project work place webpage, I see the design for large room with MX800 and two touch 10 associated. Is that supported for all SX and MX series? How many touch 10 we can connect? Thanks!

Lou 

[Manish Gogna · Accepted solution]

Hi Lou,

With TC7.2 and above the following option was added:

Peripherals Profile TouchPanels
Set the number of touch panels that are expected to be connected to the video system. This information is used by the video system’s diagnostics service. If the number of connected touch panels does not match this setting, the diagnostics service will report it as an inconsistency.
Note that only one Cisco Touch controller is supported in this version.
Requires user role: ADMIN
Value space: <NotSet/Minimum1/0/1/2/3/4/5>
NotSet: No touch panel check is performed.
Minimum1: At least one touch panel should be connected to the video system.
0-5: This number of Touch controllers should be connected to the video system.
Example: Peripherals Profile TouchPanels: NotSet

Manish

- Do rate helpful posts -