05-03-2006 06:48 PM - edited 03-13-2019 01:10 PM
05-03-2006 08:56 PM
duh! posted too quick..I already found it.
there are 2 ways to do it
1/ through jtapi xsi
2/ send request directly to phone (ip-address)
the call to do on the observed terminal:
have tested on my own phone, and works fine
send it to mute, send again to un-mute
06-23-2020 07:33 AM
Hi Sascha,
I have tried to mute myself from the call using JTAPI by using sendData(byte[]) and send the following XML to this:
<CiscoIPPhoneExecute><ExecuteItem Priority="0" URL="Key:Mute"/></CiscoIPPhoneExecute>
This is working on Cisco IP communicator but not working on Cisco Jabber softphone. Any suggestions for this..?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: