cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
187
Views
0
Helpful
2
Replies
Highlighted
Enthusiast

CCM IP Phone - Disconnect Cause Nofications to User

An IP Phone/CCM user dials an unallocated or disconnected PSTN number via MGCP or H.323. For various reasons, the gateway cannot/does not provide the caller outside dial-tone. CallManager receives the disconnect cause codes from the gateway, but since the call is not completely connected, there is no voice path established gateway. So the IP Phone plays a fast busy rather than the Telco error tones and message. The user never learns why the call failed.

Is there a way to have CallManager play or display the disconnect cause on the IP Phone?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

configure

voice call convert-discpi-to-prog

View solution in original post

2 REPLIES 2
Highlighted
Beginner

configure

voice call convert-discpi-to-prog

View solution in original post

Highlighted

Thanks! That's a big help and is exactly what I'm looking for, at least for H.323.

Does this break CDR or JTAPI cause code recognition?

Content for Community-Ad