cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
252
Views
0
Helpful
2
Replies

CCM IP Phone - Disconnect Cause Nofications to User

michael_davis
Enthusiast
Enthusiast

An IP Phone/CCM user dials an unallocated or disconnected PSTN number via MGCP or H.323. For various reasons, the gateway cannot/does not provide the caller outside dial-tone. CallManager receives the disconnect cause codes from the gateway, but since the call is not completely connected, there is no voice path established gateway. So the IP Phone plays a fast busy rather than the Telco error tones and message. The user never learns why the call failed.

Is there a way to have CallManager play or display the disconnect cause on the IP Phone?

1 Accepted Solution

Accepted Solutions

jpino
Beginner
Beginner

configure

voice call convert-discpi-to-prog

View solution in original post

2 Replies 2

jpino
Beginner
Beginner

configure

voice call convert-discpi-to-prog

Thanks! That's a big help and is exactly what I'm looking for, at least for H.323.

Does this break CDR or JTAPI cause code recognition?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers