Cisco 3640 network-clock command

[vpersaud001]

Hello,

Can anyone verify that the 3640 does NOT support network-clock commands? If not, how do you configure clocking for a PRI?

Thanks,

vp

[Manish Gogna · Accepted solution]

Hi,

Any routers with a TDM clock on the motherboard require the 'network-clock-participate' and/or 'network-clock-select' commands.

With the 3640, this does not have a TDM clock on the motherboard so these commands were not necessary. 

This is pretty much what i understand about 3640 and hence shared with you.

Manish

- Do rate useful posts -

[vpersaud001]

Thank you Manish. I was trying to setup a 3640 for dialin access over a PRI and was getting error message "modem not found due to wrong b chan num..." as documented in bug CSCsc43419. I saw a thread about using the network-clock commands to resolve. I was able to get it working by making a number of other config changes.

Thanks for your response.