cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
124
Views
4
Helpful
2
Replies
Highlighted
bej Beginner
Beginner

Class subcommand "Set" not available

Under policy-map and class i cannot get the set command listed. I want to use the "set" command to set the dscp value. Any suggestions ?

2 REPLIES 2
Highlighted
Cisco Employee

Re: Class subcommand "Set" not available

There are many ways to implement DSCP. You can use "match" command command instead of "set" command. Also its ios dependent. So i would use .T version in 12.2 or 12.3 train for that. Here are the link which talks about some other ways to set DSCP values

http://www.cisco.com/en/US/tech/tk543/tk757/technologies_tech_note09186a00800949f2.shtml

and

http://www.cisco.com/en/US/tech/tk652/tk698/technologies_white_paper09186a00800d6b73.shtml#xtocid25

Highlighted
bej Beginner
Beginner

Re: Class subcommand "Set" not available

OK, that made it clear to me. I can use the rate-limit (CAR) statement used with access lists on an interface to set value for the dscp field in the ip header. This will give the same functionality as CB marking. Thanks.

CreatePlease to create content