CME 3.3 and 7961 supported?

[kbehymerisg]

Is CME 3.3 and 7961 phones supported?

If not, what version of CME/IOS do I need to run?

Also which files are needed to tftp to 7961, i.e. firmware, config.

I have searched Cisco.com with no luck.

Thanks

[pfh]

You need CME 4.0 for 7941/7961 support. The firmware files are included in the CME 4.0 distribution. Your IOS choices are 12.4(4)-XC2 and 12.4(9)T.

[Rob Huffman]

Hi Kyle,

7961G phones are supported on CME starting with 4.0 have a look at this good doc;

Cisco Unified CallManager Express 4.0 Supported Firmware, Platforms, Memory, and Voice Products

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/prod_installation_guide09186a00805f5908.html

Hope this helps!

Rob

Please remember to rate helpful posts.........