04-25-2005 06:31 AM - edited 03-13-2019 08:52 AM
Hi everybody.
I would like to connect two cisco router in lan with h323 protocol. How can I do it?
If anybody know how do it or link to site please write here.
Thanks before
04-25-2005 07:07 AM
Is it plain voip between the routers, using h323 ? What are the end points ? Analog phones connected to FXS ports ? Need more details.
04-25-2005 08:04 AM
04-25-2005 09:08 PM
Anyony can help me ?
Anyony configure router with h323 protocols to connect in the lan with another router ?
04-25-2005 09:14 PM
On gate1 :
dial-peer voice 1 voip
destination pattern xxxx
sessoin target ipv4:
codec g711ulaw
dtmf-relay h245-alphanumeric
On gate2 :
dial-peer voice 1 voip
destination pattern xxxx <-- phones at CM1
sessoin target ipv4:
codec g711ulaw
dtmf-relay h245-alphanumeric
04-26-2005 07:53 AM
Thanks for help but it not working.
In my ccm route-pattern is 5XXXX when Anyone press 5 and then ext 2004, CCM route this call to h323 gate in router and no digits is strips.
I configure ethernet interface h323 gateway with that command :
h323-gateway voip interface
h323-gateway voip bind srcaddr 172.16.0.150
Can you send full simple config or I send you my config and you correct it
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: