Could anyone give help me in installing dmm 5.3 in UCS -SERIES SERVER

[Rajeshkannan Vaigundavasan]

I am trying

to install DMM-5.3.0.244.isov in the UCS  B-series  server
i am getting the below error

Could anyone help.

Please give me the alias for DMM.

[Mike Assel]

DMM is not supported on the B series.

[Rajeshkannan Vaigundavasan]

Hi Mike,

I have also tried with the c-series server, am getting the same error.

Please help.

Can you give alias for DMM.

[Mike Assel]

http://www.cisco.com/en/US/partner/docs/video/digital_media_systems/5_x/5_3/dms/aai/administration/guide/intro.html

Supported Appliances

This document describes how to set up and administer the following Cisco Digital Media System (DMS) 5.2.x appliances:

•Cisco Show and Share appliances:

–Cisco Show and Share 5.3.x on MCS 7835-H3

–Cisco Show and Share 5.3.x on WAVE-574

–Cisco Show and Share 5.3.x on UCS C210 (SNS-SVR-C210EN-K9)

–Cisco Show and Share 5.3.x and Cisco Show and Share Reports 5.2.2 on UCS C200 (SNS-SVR-C200WG-K9)

•Cisco Digital Media Manager appliances:

–Cisco Digital Media Manager 5.3.x on MCS 7835-H3

–Cisco Digital Media Manager 5.3.x on UCS C210 (DMM-SVR-C210-K9)

[Mike Assel · Accepted solution]

Which C series?

[Rajeshkannan Vaigundavasan]

C210 series i have installed but getitng error

Thanks a lot.

[Mike Assel]

WHere did you get the iso you are using?  I'm not familiar with that version.  Is this a fresh install or an upgrade?  Normally you have to upgrade from 5.2 to get to 5.3.  You can't do a fresh 5.3 install unless you have a special iso that someone from Cisco posted to you.

[Mike Assel · Accepted solution]

So I do have the same iso image you are trying to use.  I think you may have an incorrect hardware configuration on your C210.  Is it an off the shelf C210 or was it purchased as a DMM?  I'm pretty sure DMM is only supported on a C210 that has hardware specd specifically for the DMM.  Basically it is an appliance. 

Cisco Digital Media Manager 5.3.x on UCS C210 (DMM-SVR-C210-K9)

I don't think I can't help you from here.  You will have to contact TAC.

[Rajeshkannan Vaigundavasan]

i have 2 doubts still

1. i have only ucs server which is not purchased as dmm, can i try  with DMM 5.4 VM image whether it will work.

2.

I need to implement Digital signage solution in my office workplace.

I have DMP 4400G and TV only , can I implement the solution without DMM,SNS,Stadium vision director.

Please suggest me your valuable inputs

Thanks a lot for your great support.

Rajesh