cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1036
Views
5
Helpful
3
Replies

cucm

what is the use "run on all active cm nodes " in sip trunk?

what will happen if u enable that ?

what is the behaviour if we disable that?

2 Accepted Solutions

Accepted Solutions

Kalliopi Vazima
Level 1
Level 1

Hello,

 

if you have a deployment of a cluster (PUB & Sub) every time you create a trunk in the PUB and activate "run in all active nodes" this trunk applies to all cluster members(SUB) too.

 

Kalliopi

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

View solution in original post

If you don't enable it, the trunk will only run on devices within the devices in the CUCM group.

If checked it will run on all active nodes with the cucm service enabled.

View solution in original post

3 Replies 3

Jaime Valencia
Cisco Employee
Cisco Employee

Please use descriptive titles for posts and not just "CUCM" every time you post to make it easier for people to know what you're asking. What you're asking has been discussed several times before at CSC, have you looked at those posts? 

HTH

java

if this helps, please rate

Kalliopi Vazima
Level 1
Level 1

Hello,

 

if you have a deployment of a cluster (PUB & Sub) every time you create a trunk in the PUB and activate "run in all active nodes" this trunk applies to all cluster members(SUB) too.

 

Kalliopi

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

If you don't enable it, the trunk will only run on devices within the devices in the CUCM group.

If checked it will run on all active nodes with the cucm service enabled.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: