cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7780
Views
30
Helpful
4
Replies

Default PAssword for UCS-E card(UCS-E140S-M2/K9)

Rajesh Kalra
Level 1
Level 1

Hi,

I am configuring a new UCS-E card UCS-E140S-M2/K9 which is installed on a Cisco 4400 voice gateway..

 

When I login to CIMC , the default login credentials of admin/password do not work as per the Cisco website.

The Getting Started Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine - says :-

"When logging in for the first time to an unconfigured system, use admin as the username and password as the password."

 

However this doesn't work.

 

Can somebody please advise ?

4 Replies 4

edsge teenstra
Level 1
Level 1

Hi have you found a solution for this , i have this too ... 

 

Thanks 

R0g22
Cisco Employee
Cisco Employee
If you do a "hw-module session <slot/card>" for the UCS, do the admin/password work on the CLI ?

Alternatively, you can do a "ucs subslot <slot> imc password-reset" command. The default should be "password" post that.

Thanks for the reply, i managed to reset the UCS.

Cheers

Im having the same issue, password reset didnt work for the IMC

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: