DMP 4400G WiFi with certficate

[smailmilak]

Hi,

one question guys.

Can the DMP 4400G authenticate using  a certificate, without using a preshared key?

[sdhanral]

Hello,

  The current DMP-4400 firmware cannot authenticate using the certificates, You are restricted to the use of the Pre-shared secret key. The supported security protocols are WPA, WPA2, EAP-FAST, and WEP.

Please refer to the datsheet and configuration guide for futher details

http://www.cisco.com/en/US/docs/video/digital_media_systems/dmp/user/guide/5_x/5_2_x/network.html#wp1157593

http://www.cisco.com/en/US/prod/collateral/video/ps9339/ps7220/data_sheet_c78-480272.html

If this addresses your concerns -Please mark this post as answered.

Regards,

Sagar Dhanrale

[Smailmilak83_2]

Thank you. I looked only in the data sheet, not in the user guide.

[sdhanral]

Hello,

  Can you please take some time to rate the answer along with marking this post as "Answered" ?

Sagar D

[Smailmilak83_2]

I would do that if I knew where to klick

[sdhanral]

Here you go :

https://supportforums.cisco.com/docs/DOC-6022#I_posted_a_question_how_do_I_mark_a_reply_as_Correct_Answer

Also here is a document demonstrating how the rating feature works : https://supportforums.cisco.com/docs/DOC-8052

Regards,

Sagar Dhanrale

[Smailmilak83_2]

I know now why I dont see the "correct answer" button.

I created the thread with my CCO username and not with my support forums username.

I dont know how I managed to log in with my CCO account.

Now I can not log in and thus mark your answer.

Any idea?