cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1258
Views
0
Helpful
3
Replies

Do you need DSP's for a HWIC-4B-S/T

jsmckinlay
Level 1
Level 1

Hi,

It's been a while since I deployed any new voice routers, I have a need for 8 BRI ports on a new router, do I need a PVDM DSP chip for this? I am looking at a 2901 with 2 HWIC-4B-S/T

Thanks

Jon

1 Accepted Solution

Accepted Solutions

No. You install them directly on the chassis together with the PVDM3.

Please remember to rate useful posts clicking on the stars below.

View solution in original post

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

HWIC-4B-S/T does not support voice, and does not requires DSP to work for its data-only functions.

for 8 BRI, you will need 4x VIC2-2BRI-ST/TE and a minimum of PVDM3-16.

Thanks Paolo,

I'll need to check exactly which BRI module is on our existing setup.

Asssuming I need 4 X VIC2's would I need to put those on a HM-HD-2V? (and therfore need a bigger router than a 2901)

Thanks

Jon

No. You install them directly on the chassis together with the PVDM3.

Please remember to rate useful posts clicking on the stars below.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: