E1 Back to Back

[ROLAND MARTI]

Hi

i would like to connect two E1 interface on 3845 Router to simulate E1 traffic.

Has anyone a sample config for the two Routers.

Thanks Roland

[ciscogini]

What are trying to accomplish,

1. E1 Data

2. E1 Voice

[ROLAND MARTI]

Hi i would like to transport E1 Voice.

Do you have an idea.

Roland

[spremkumar]

Hi

What kinda hardware being used up there thats the card type being used in ur 3845 router ?

regds

[ROLAND MARTI]

We have two

CISCO3845-SRST/K9

with VWIC-1MFT-E1 interface installed.

regds

[spremkumar]

Hi

i feel these pin details would help u out..

Pin 1 to 4

Pin 2 to 5

Basically the mentioned pairs are correlated to TX , RX..

If it doesnt work u mite need to try

1 ----- 4

2 ----- 5

4 ----- 1

5 ----- 2

the above pin details includes RX/TX ring pair points too in addition with RX/TX pair..

regds

[ROLAND MARTI]

Thanks for information.

I have the cable allready but i need the config commands for the two routers.

regds

[Aaron Harrison]

Hi

How far have you got so far?

You'll need to enter

clock source internal

Under the E1 controller on one router... then configure your signalling types/etc - what type of setup are you trying to create?

Aaron

[thisisshanky]

Are you trying to configure this as a E1 PRI for transporting voice calls ?

set both sides with linecode, framing and a pri-group command specifiying number of channels. Under the D channel, set one end as network side and other end as user side (defaults). (isdn protocol-emulate network | user)

HTH