11-11-2005 05:40 AM - edited 03-13-2019 11:12 AM
Hi
i would like to connect two E1 interface on 3845 Router to simulate E1 traffic.
Has anyone a sample config for the two Routers.
Thanks Roland
11-11-2005 03:10 PM
What are trying to accomplish,
1. E1 Data
2. E1 Voice
11-14-2005 05:49 AM
Hi i would like to transport E1 Voice.
Do you have an idea.
Roland
11-14-2005 05:59 AM
Hi
What kinda hardware being used up there thats the card type being used in ur 3845 router ?
regds
11-14-2005 07:02 AM
We have two
CISCO3845-SRST/K9
with VWIC-1MFT-E1 interface installed.
regds
11-14-2005 08:05 AM
Hi
i feel these pin details would help u out..
Pin 1 to 4
Pin 2 to 5
Basically the mentioned pairs are correlated to TX , RX..
If it doesnt work u mite need to try
1 ----- 4
2 ----- 5
4 ----- 1
5 ----- 2
the above pin details includes RX/TX ring pair points too in addition with RX/TX pair..
regds
11-14-2005 08:09 AM
Thanks for information.
I have the cable allready but i need the config commands for the two routers.
regds
11-14-2005 03:42 PM
Hi
How far have you got so far?
You'll need to enter
clock source internal
Under the E1 controller on one router... then configure your signalling types/etc - what type of setup are you trying to create?
Aaron
11-14-2005 08:20 PM
Are you trying to configure this as a E1 PRI for transporting voice calls ?
set both sides with linecode, framing and a pri-group command specifiying number of channels. Under the D channel, set one end as network side and other end as user side (defaults). (isdn protocol-emulate network | user)
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide