Hello my dears,
the situation is we have the following:
Cisco ISE , CUCM Cluster, Cisco IP phone, Cisco DX80
our target is to make the IP phones & DXs authenticate using DO1X not MAB (on ISE).
already installed the LSC certificate by the CUCM to all IP Phones and DXs and created the authentication policy on ISE and
now the ip phones are done .
-the problem is with the DX80, it authenticate using the MAB.
-the LSC operation status is pending on the LSC (checked from the CMadmin page).
-there was no configuration on the DX80 on the CUCM profile but after searching found that
80.1x can be configured from the GUI of the DX80 itself, I configured it but still using MAP
any idea how to make it authenticate using the LSC certificate