cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
130
Views
0
Helpful
1
Replies
Highlighted
Beginner

Gateway problems with vic-2fxs

Hello,

I Want to use a Cisco2611 with a vic-2fxs module as a gateway with the CM 3.3(4). Below is my GW Configuration. I can not dial to an outside line ?

If if dial an outside number then i hear the ringing tone, but the outside telefone is not ringing

what am i doing wrong ?

Regards,

Erik

version 12.3

!

hostname GW

!

no ip domain lookup

!

ccm-manager redundant-host 192.168.1.80

ccm-manager mgcp

!

interface FastEthernet0/0

ip address 192.168.1.1 255.255.255.0

duplex auto

speed auto

!

ip default-gateway 192.168.1.254

ip classless

!

voice-port 1/0/0

!

voice-port 1/0/1

!

mgcp

mgcp call-agent 192.168.1.70 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp sdp simple

!

mgcp profile default

!

dial-peer voice 1 pots

application mgcpapp

port 1/0/0

!

1 REPLY 1
Highlighted
Beginner

Make sure your CCM config is correct and the configured DN matches what you are dialling

When making the call, when you hear ringing tone type on the router "sh voice port summary"- this will tell you if the voice-port is ringing.

If not and you see all ports idle then the call never came to this router. If you see ringing (or something else that indicates not idle) then try lifting the handset and see if you are connected.

I had the same problem when I connected my BT phone (which has a BT plug at the end) into the FXS port via a BT-to-RJ11 adapter. I had to use a Master BT adapter which contains a capacitor which allows the phone to ring.

Hope this helps.