I would like to dial one extension that forks to two extensions

1damianjones · ‎07-09-2018

We upgraded from a CME2821 to CUCM11.5. A part of this upgrade was losing the ability to utilize our paging system. Our current setup is dn *88 connects to the paging system and dn 7778 pages to our phones on the Informacast SingleWire basic system. What I would like is to have one dn open a connection to *88 and 7778.

Thanks.

johnd2310 · ‎07-09-2018

Hi,

Not sure what you are using for the paging system but can you not integrate the paging system with infomacast using the "Singlewire Legacy Paging Interface (LPI) ?

Thanks

John

**Please rate posts you find helpful**

1damianjones · ‎07-10-2018

@johnd2310 wrote:

Hi,

Not sure what you are using for the paging system but can you not integrate the paging system with infomacast using the "Singlewire Legacy Paging Interface (LPI) ?

Thanks

John

I have the basic version which only connects to the phones. There isn't a Singlewire Legacy Paging Interface listed anywhere in the menu.

Thanks,

Damian