cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

670
Views
0
Helpful
0
Replies
luceilina
Beginner

If You have forgotten UCS password, how to recover it?

If you have forgotten the password, you can set a new password. Connect to the console of Cisco UCS  6100 series fabric interconnect. Reload the fabric interconnect and when it boots up hit ctrl+L or ctrl+shift+R to go to loader prompt then boot the kickstart image; if you have two fabric interconnects connected in HA then first reload the subordinate fabric interconnect and bring it in loader prompt and then reload the primary and bring it in loader prompt, after this load kickstart image on primary. Configure the admin password using “admin-password” command by going to config terminal mode. Now load the system image on the fabric interconnect or if you have HA load system image on the primary fabric interconnect. The password is now set to the new password you have just configured; if you have HA then now you can load the kickstart and system images on the subordinate fabric interconnect.

 

UCS is a set of pre-integrated data center components that comprises blade servers, adapters, fabric interconnects, and extenders that are integrated under a common embedded management system. This approach results in far fewer system components than comparable data center platforms.

Lucie Lina
0 REPLIES 0
Content for Community-Ad