cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
458
Views
0
Helpful
4
Replies
Beginner

Information about channel negotiation E1

hi,

anyone knows if is it possible to negotiate an outbound ISDN b-channel between Cisco gateway 2851 and a PSTN switch of an Italian provider?

I have a Cisco router 2851 linked via E1 PRI (primary-net5) with PSTN and connected via MGCP with Cisco Call Manager v4.1.

From the debug message I note that the router choose the b-channel in esclusive mode and if, for any reasons, there is a problem on the line the call is busyout.

Thank for helping me

antonio

4 REPLIES
Participant

Re: Information about channel negotiation E1

Can you post the configs of the router? Thanks.

Beginner

Re: Information about channel negotiation E1

Below the lines more relevant. We have also an E1 link (via E1 0/2/0) between our gateway and our alcatel 4400 PBX.

network-clock-select 1 E1 0/0/0

network-clock-select 2 E1 0/1/0

network-clock-select 3 E1 0/1/1

network-clock-select 4 E1 0/3/0

network-clock-select 5 E1 0/3/1

isdn switch-type primary-net5

controller E1 0/0/0

pri-group timeslots 1-31 service mgcp

controller E1 0/2/0

clock source internal

pri-group timeslots 1-31 service mgcp

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

isdn negotiate-bchan resend-setup

no cdp enable

interface Serial0/2/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn protocol-emulate network

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

!

voice-port 0/0/0:15

cptone IT

!

voice-port 0/2/0:15

cptone IT

!

ccm-manager mgcp

no ccm-manager fax protocol cisco

ccm-manager music-on-hold

ccm-manager config server xxx.xxx.xxx.xxx

ccm-manager config

!

mgcp

mgcp call-agent xxx.xxx.xxx.xxx 2427 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp modem passthrough voip codec g711alaw

mgcp package-capability rtp-package

no mgcp package-capability res-package

mgcp package-capability sst-package

no mgcp package-capability fxr-package

mgcp package-capability pre-package

no mgcp timer receive-rtcp

mgcp sdp simple

mgcp fax t38 inhibit

mgcp rtp payload-type g726r16 static

!

mgcp profile default

dial-peer voice 1 pots

service mgcpapp

port 0/0/0:15

Hall of Fame Master

Re: Information about channel negotiation E1

Hi, you asked this already.

You cannot chanhe the selection using MGCP.

With H.323, you are able to.

Re: Information about channel negotiation E1

I'm not sure if this is what you're asking, but on the MGCP page you're able to specify whether you want to do 'top-down' or 'bottom-up' on the PRI page.

-nick

CreatePlease to create content
Ask the Expert- Webex Hybrid Services Solutions