cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

interdigit timeout in CM 3.1

MANUEL HEIANNA
Beginner
Beginner

I must change the interdigit timeout in a CM 3.1.

I have used this service parameter in version 3.0(8), but I can not find it in this new version.

1 REPLY 1

j.ayres
Beginner
Beginner

Change the value of the following CallManager service parameter:

TimerT302_msec

This is normally set to 10000ms

Hope this helps.

Justin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: