06-07-2002 10:58 AM - edited 03-12-2019 07:08 PM
We would like to place IP/VC equipment at a customer site. I would like to utilize a secure point-to-point connection at 512K between us and the customer. Customer site will only need one end-point. Interenally, we have 3525 IP/VC Gateway, 3510 MCU, and 2610 for GK/QoS/Proxy. Gateway is connected to ISDN PRI so we can support legacy H320-basede systems. What would be needed at customer site? I will use the PTel iPower 680 as the end-point. Any suggestions on the link - QoS-Enables IP WAN, Fract T1, or Frame Relay? Anyone with prior experience and ideas? THanks
06-09-2002 01:46 PM
Far end site needs a 25xx or better router. IP WAN link could be any you describe - IP VPN from QoS enabled carrier, Frac-T1, Frame Relay. - whatever works out least expensive. 768k access recommended to avoid need to fragment packets. Other configs will vary based on aggregate traffic you expect. Provide more info and I will make additional recommendations. Good luck.
06-10-2002 05:43 AM
Only other planned traffic over the link will be Voice. We plan on placing some IP 7960 Phones out at this customer's site (probly no more than 3). I belive the calls wont use more than 80K....
The idea we are looking at is that we want to provide our partner level customers w/ a no-cost solution for VC and Voice communications. Doing both over IP is what I am planning to propose and do a feasibility on.
06-18-2002 10:31 AM
Don't think you need more than what I previously listed. Should make sure that aggregate bandwidth you configure accounts for all concurrent flows + IP overhead requirements. Other than that, with all real-time UDP media flows, network has no congestion points that would cause packet loss, delay or jitter
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide