01-10-2005 07:01 AM - edited 03-13-2019 07:35 AM
Hello,
While I was debugging my ISDN connections, I have noticed that the caller number is always incomplete.
In my case, the "0" of the local area code is missing.
Do you think that it's a normal line provider behaviour?
Thanks.
Solved! Go to Solution.
01-10-2005 08:25 AM
We all met this problem. The first number depends of the Telco provider so as you sometimes can choose your operator, this first number is always missing on incomings calls.
You can add it 2 ways :
- with an H323 gateway using CLI transformations :
*create your translation rule :
translation-rule 1
Rule 0 ^1 01
Rule 1 ^1 01
Rule 2 ^2 02
Rule 3 ^3 03
Rule 4 ^4 04
Rule 5 ^5 05
Rule 6 ^6 06
*apply it on your voip dial peer
translate-outgoing calling 1
- with an MGCP gateway with CCM4 you can set up National and International Number Prefix in the CCM's Service Parameters (Service>Service Parameters then choose your CCM and click the Advanced Button)
You'll find lots of post about these configurations on this forum
Regards,
Marc
01-10-2005 08:25 AM
We all met this problem. The first number depends of the Telco provider so as you sometimes can choose your operator, this first number is always missing on incomings calls.
You can add it 2 ways :
- with an H323 gateway using CLI transformations :
*create your translation rule :
translation-rule 1
Rule 0 ^1 01
Rule 1 ^1 01
Rule 2 ^2 02
Rule 3 ^3 03
Rule 4 ^4 04
Rule 5 ^5 05
Rule 6 ^6 06
*apply it on your voip dial peer
translate-outgoing calling 1
- with an MGCP gateway with CCM4 you can set up National and International Number Prefix in the CCM's Service Parameters (Service>Service Parameters then choose your CCM and click the Advanced Button)
You'll find lots of post about these configurations on this forum
Regards,
Marc
01-10-2005 12:25 PM
Thanks Marc.
Marco.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: