cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

691
Views
0
Helpful
3
Replies
Highlighted
Beginner

Issue with Media URL display in 4305G

I can run a mpeg URL if it is posted in Media URL within DMP by clicking Start but if I try sending the same URL either through Startup URL or as a Job I get an error "Write enable the disc or try different folder."

Everyone's tags (3)
3 REPLIES 3
Cisco Employee

Re: Issue with Media URL display in 4305G

Pankjb,

What is the format of the Video Content?

What is the sample URL that you are using?

What DMS-DMP version are you running on the 4305G?

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use

the MEDIA URL.  I have tested and it works fine.

If this answers your question, Please take time to mark this

discussion answered & rate the response.


Thank You!


T.

Beginner

Re: Issue with Media URL display in 4305G

What is the format of the Video Content? MPEG.

What is the sample URL that you are using? http://10.1.10.10/test.mpeg

What DMS-DMP version are you running on the 4305G? 5.2

In 5.2,  There is a Startup "Media" & "Browser" URL.  For "video" content you need to use the MEDIA URL.  I have tested and it works fine.

Yes when I paste this url in Dispaly Actions --> Media URL and press Start works fine. But the same URL I try to submit using Go To URL it gives error "Write Protected". If I give the same as Startup URL in Media - no display.

Cisco Employee

Re: Issue with Media URL display in 4305G

Please provide screenshots of the following screens from

the DMP-DM:

* Settings->Basic

* About->Hardware and Firmware Versions

You mention:

"But the same URL I try to submit using Go To URL it gives error "Write Protected"."

There is no "Go To URL" setting where are you seeing that?

thanks


T.

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here