I have seven MCS 7825 I1 servers which until recently have been working perfectly. We recently had a power failure on site shutting down all seven servers. After the power was restored two of the servers reported that they have 6 GHz processors. One is now working again, but I cannot restore the correct CPU speed on the final server. It completes the RAM tests, tries to boot from hard drive and then freezes. Any suggestions please.
hi Team, we are planning to deploy Multi-Factor Authentication for Jabber. The main requirement is to use MFA over internet (MRA).Is it possible to deploy MFA just for MRA and don't touch impact any on-prem existing setup?Can someone please guide on ...
Looking to expand your professional network? Interested in gaining an edge with exclusive technology insights? Engage with Cisco experts, share feedback on products and connect with peers from across the globe. Cisco Champion 2021 applications are open fo...
UCCX does not natively protect HTTP Triggers.
I wanted to come up with a solution to handle HTTP cookie based authentication.
There is a zip file for this project attached to this article. It was written on UCCX 12.5...
CUCM can backup the manually or have sehchduler to backup the configuration and historical reports from the server diester recovery systemStep 1. Navigate to CUCM > Disaster Recovery System > Backup > Manual Backup as shown in the...