MIBS and OID Numbers for DS0 Utilization on 3640 with NM-HDV

[limeish]

Hello

I am trying to use mrtg to graph my current calls on my Cisco 3640. However I am having difficulty with OID #s.

Refering to cisco page http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/dialsol/nmssol/mrtg.htm#31188

I'm trying to use 1.3.6.1.4.1.9.10.19.1.1.4, to measure active calls, and it keeps returning a 0 value even though I see calls on the router.

I'm using it to measure calls off an as5300 and it works fine.

Is this the right OID? Is there an instance other than 0 to use?

Thanks

Lawrence

[esh]

here is what i am using on my 3640

Target[Modem_Useage]: 1.3.6.1.4.1.9.9.47.1.1.6.0&1.3.6.1.4.1.9.9.47.1.1.6.0:public@ip_address

MaxBytes[Modem_Useage]: 24

Title[Modem_Useage]: 3640NAS

PageTop[Modem_Useage]: Modem Utilization on 3640NAS

YLegend[Modem_Useage]: Modem Utilization

Options[Modem_Useage]: gauge, nopercent, unknaszero

ShortLegend[Modem_Useage]: Modems

Legend1[Modem_Useage]: Modem Utilization  

Legend2[Modem_Useage]: .

Legend3[Modem_Useage]: Max value per interval on graph

Legend4[Modem_Useage]: .

LegendI[Modem_Useage]: Utilization:

LegendO[Modem_Useage]: .

Colours[Modem_Useage]: GREEN#00eb0c,BLUE#0000ff,GRAY#AAAAAA,VIOLET#ff00ff

WithPeak[Modem_Useage]: ymw

[limeish]

Hi There,

Thank you for your fast reply, I tried 1.3.6.1.4.1.9.9.47.1.1.6.0 and still returned a value of 0.

I have a cisco 3640, with an NM-HDV2T1-48, located in slot 1, my Channelized T1s are 1/0 and 1/1

I need to see how many voice calls are up at any given time.

Thanks again,

L

[rmushtaq]

Read the definition of .1.3.6.1.4.1.9.9.47.1.1.6

carefully first. It will not give you the number of active voice calls currently in place. It gives the current state of the modems like connected, offHook etc.