Modem Connected to VG224

[Ivan Villagomez]

Hello Guys

I have a VG224 coonected to my CCM using SCCP.

I have a telephone connected to voice-port 2/0 in the VG224 and it works fine, but if i connect a modem in the same port, the modem dont ring, in fact i dont even get signal to the modem from the VG.

Any clues about this? should i have a special configuration on the VG?

THX in advanced.

Current COnfig:

CCM 4.2

VG224: Version 12.4(10b)

[Mark Turpin]

Try turning off clid on the port

[Ivan Villagomez]

I found the problem, after some testing the modem was ringing answered the call but didnt established the communication. all i did was to use MGCP and it works now.

For incoming call from the outside to that modem i had to configure the modem-passtrough command on the dial-peer voice voip.