Multi tenant setup

[pengkeong.fong]

Dear Everyone,

I am currently going to setup a multi tenant environment for 2 different customer (A & B) using a redundant pair of Call manager and 1 x Cisco3725 with 2 x E1 link as Voice gateway. I had configured H.323 for the voice gateway.

Customer A will use the first E1 link for external call to PSTN.

Customer B will use the other E1 link for external call to PSTN.

How can I ensure call from IP Phones on the two customer to use their respective E1 link for outgoing call?

On the call manager side, i can only configured 1 x Loopback IP address of the Cisco3725 for H.323 signalling!

Thank you!

[8r-schumann]

I would not use H.323 has the protocol for the 3725.

If you use MGCP then it is very easy to make sure that your different tenants use only specific recources in the 3725.

A simple example would be to place all the route patterns for customer A in one partiton pointing to one of the gateway endpoints and that partiton in only the CSS for customer A. And vise versus for customer B. That will keep them seperate.