cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

701
Views
0
Helpful
0
Replies
Beginner

Multiple/Sequence Serial Codes DMP 4400G

I have a DMP 4400G connected to a Samsung 460CX-2. I currently have advanced tasks for the following actions: Turn On, Turn Off, Switch to HDMI Input, Set Volume. We use digital signage with no audio primarily, however, we are tying it in with our emergency alert system and we want to have an alarm sound for ADA issues.

So basically what I would like is to create a system task that could be ran prior to pushing an emergency presentation that would do the following: Send TV On Command (in case TV is off), Switch TV to HDMI Input (in case the tuner is being used for cable TV), Set Volume command (so alarm can be heard).

Is there anyway to do this in a single task? It is a real pain to have to run three separate tasks especially when time is of the essence in an emergency. Any help would be greatly appreciated. Thanks in advance.

Everyone's tags (5)
CreatePlease to create content
Content for Community-Ad
FusionCharts will render here