07-05-2002 06:12 AM - edited 03-12-2019 07:45 PM
I am trying to get Netmeeting to talk to a 5300 with a PRI line. Everything goes fine until the other side answers, but then NM keeps saying "connecting", while on the gateway the call is shown as active. Same configuration works fine against a 3640 with FXO, located in the same subnet as the 5300, so this rules out communication problems. Also, we have set the bearer cap on the PRI port to voice. We have tested with Intel Internet Phone, with similar results.
Has anyone got a NM to work against a 5300 with PRI?
07-05-2002 10:36 AM
Are you using NAT anywhere within in this?
07-09-2002 05:27 AM
No, we are not using NAT.
07-10-2002 01:08 AM
I had the same problem with AS5300 and NetMeeting 3.01.
Problem was with IOS and VCWare verssion.
Proper communication was when I us IOS oldes as 12.2.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide