I've configured many NIM-2BRI cards in 4321 with success but in 4331 the same commands can't make the card work.
I've tried different other commands with no success.
If anyone knows something useful for this to work please share it with us.
The problem is that I have no audio in calls or audio with very bad noise.
Solved! Go to Solution.
I've tried in 4331 the same version I had in 4321 which is the 16.5.2b
I've also tried in 4331 the version 16.6.3 which is the recommended one.
The output is the bellow.
Router#show platform software subslot 0/2 module firmware
DSPware Version 46.2.3, built on Dec 11 2017:13:16:18 from kctsai-DSPWARE_46_2_3
NGIO Version ngio@v166_throttle/5
TDMSW registers (fpga ver = 0x10300, 2+0 analog ports)
FPGA misc_ctrl = 0x00
FPGA tdm_pll_cntl = 0x00
FPGA tdm_pll_status = 0x02
I have to inform you that I've tried 3 different NIM-2BRi NT/TE cards in 3 different 4331 Routers with multiple IOS with the same exact results.
Let's focus though in finding the problem as I believe is the same in all my tests.
Thank you in advance.
My friend you are absolutely right.
I upgraded to version 16.7.2 and I made a successful call.
Unfortunately with this version I had the message "%PLATFORM-4-ELEMENT_WARNING: R0/0: smand: RP/0: Used Memory value 89% exceeds warning level 88%" which is the bug CSCvf59313
I upgraded to version 16.8.1 and I also made a successful call.
In this version I had the message " %HMAN_CPU-3-PAGE_FAULT_HIGH: R0/0: hman: CPU Usage due to Memory Pressure (64) exceeds threshold (50) on BINOS_FRU_RP".
I believe I will leave the version 16.8.1
Cisco should mark this as a bug.
Thank you so much my friend!!
My friend the IOS you suggested have many bugs.
They may be good in order for the BRI to work but they create other problems with the RAM or the CPU of the 4331 router.
Is there a way to have the card work with the suggested 16.6.4 Everest or the 16.3.6 Denali IOS.
Can we do something in the card?