cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
364
Views
0
Helpful
3
Replies

NM-HDV2-2T1/E1 with ccm4.0(2)

subbarao.s
Level 1
Level 1

Has any one successfully configured the module in the subject for MGCP support with E1 PRI QSIG with CCM4.0(2)? Any issues in specific?

Is onboard T1/E1 ports are accessible from gateway confiugraiton window of CCM for this module?

Thanks!

3 Replies 3

thisisshanky
Level 11
Level 11

Have done it with T1 PRI and CAS. I had 4.01 and it didnt show the module in gateway configuration page. I had to upgrade to 4.01SR2 to make it work. Since you have 4.02, I think it should be already supported..

Also remember to give "cart type e1" command to make those onboard ports type E1.

You might end up having issues with MGCP and the module depending on what IOS you run. I think the latest now is 12.3.11T thats supported.

Sankar Nair
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus

Thanks Shanky!

I already selected appropriate IOS with Release notes help. Only worry is MGCP support with the CCM for this module.

Thanks!

Can you please post your config.

thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: