08-22-2002 11:38 AM - edited 03-12-2019 08:28 PM
CM3.2(2a), 3660 w/ 12.2(2)XT3 w/ FXO port to Bogen ZPM3. H323 configuration something like:
dial-peer voice 20 pots
destination-pattern 200
port 2/0/0
voice-port 2/0/0
timing hookflash-out 50
IP phone dials 200, FXO port status flashes green briefly then disconnects.
I have implemented this type of config successfully at other client locations. Using a butt set directly to the T & R connections yeilds preample tone (in other words it works with an analog device).
I suspect an IOS or CM issue, a TAC case, and lots of debug baloney.
;-)
Any help would be appreciated before I go this route.
08-22-2002 04:59 PM
From the manual I read- http://www.bogen.com/pdf/54-5891-03.pdf this can be either loop-start trunk, ground start trunk (either can be FXO), or a station level port (which needs an FXS). Make sure you have the right connections.
08-23-2002 07:01 AM
Understood. I have implemented this same config before at other client sites and was looking for something new related to changes in IOS or CM software.
08-19-2010 03:39 PM
Brian,
What was the outcome of this problem? I am in the same situation.
Thanks,
Dan
05-24-2012 04:48 PM
were u able to fix the issue? please put up the solution and gateway config. thanks.
05-25-2012 11:28 AM
The config on the FXO port is correct. Verify if you need power or not and you won't be able to tell by looking directly at the paging system. I would suggest to get a TAM-B w/power supply as you'll need it with your FXO. This usually solved issues I came across dealing with paging connectivity issues
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide