cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
353
Views
4
Helpful
3
Replies

PSTN calls

Aman Soi
VIP Alumni
VIP Alumni

Hi All,

We are facing a problem while making PSTN calls to outside world using Cisco 2800 router configured as H.323 Gateway & integrated to Call Manager version 4.x.

On the router we have , VWIC-2MFT-E1 card on which PRI is terminated.

Setup was working fine but now when we call up, we need to dial two or 3 times before call gets matured.

router detail : c2800nm-spservicesk9-mz.123-11.T10.bin

can somebody guide on the same...

regds,

aman

3 Replies 3

Check status of your e1 line.

Show controller e1 x/x brief and show isdn service.

you can run debug isdn q931 and check what's going on as well.

nesharm2
Level 1
Level 1

Aman,

Apart from good suggestions from konrad

good things to check

1.what changed if it was working before ?

2.Did you have "direct indward dial" command under pots dial peer ?

Can you post the results of

sh isdn status

sh voice dsp

sh voice call summary

Do you know how many B and D channels you have on your PRI, could be possible that your using all the channels available on the PRI.

Regards,

Justin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: