04-04-2005 06:49 AM - edited 03-13-2019 08:37 AM
Hi folks. Has anyone seen the problem of a few Q931 channels (6 in this case) being forced into an auto-blocked state by the Ericsson AXE10 exchange? The E1 module on the 2651 gateway has been changed, also the NTE at the user end of the circuit. In the exchange the circuit has been totally relocated to a different part of the exchange using completely different harware, but still these channels remain auto blocked. The only way to clear them is for the exchange engineer to put his test gear on the exchange kit. When he reconnects the circuit it's ok for a day or so then the first 6 channels auto-block once more.
04-08-2005 06:48 AM
I think the following Interoperability guide will help you out.
04-20-2005 11:38 PM
Thanks for your reply - but I actually found the problem in the config of the E1 gateway. Something I didn't notice before was the tick-box (on by default) which inhibits PRI restarts from the exchange! Unticked it and reset the gateway. All channels up.
Thanks/regards
Andy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide