cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

PVDM, FXO and E1

khaled masri
Beginner
Beginner

Dear all

can you please clarify this scenario:

i have an ISR4321-V/K9 and NIM-4FXO=

and our Future plan to have E1 cable, and increase the number of phone cables.

i know that FXO card with ISR4321, we do not need to add PVDM module, because new FXO cards have on board DSP.

can you Please Clarify if we need an PVDM module ???

and thanks a lot

1 ACCEPTED SOLUTION

Accepted Solutions

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

YES you need to install a PVDM in the NIM that will have the T1/E1

HTH

java

if this helps, please rate

View solution in original post

6 REPLIES 6

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

Yes, E1/T1 NIMs do not have built-in PVDM and you need to buy a module that has enough capacity for the ports.

HTH

java

if this helps, please rate

Dear Jaime Valencia

can you please more clarify, we buy an ISR 4321 with FXO.

but in the future we will install an E1 line cable from our ISDN provider.

i want to know if its important to have the PVDM4-32 for the E1

or we can use the FX0 for E1 Line

and thanks a lot.

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

YES you need to install a PVDM in the NIM that will have the T1/E1

HTH

java

if this helps, please rate

Thanks for Help.

saif musa
Enthusiast
Enthusiast

Khaled , 

 

Cisco provides awesome tool that calculates your needs about DSP cards and PVDMs. Chick link below, it will help

https://www.cisco.com/web/applicat/dsprecal/dsp_calc.html

 

Regards

Thanks for Help
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: