QSIG , CCM, H323 gateway and Calling name

[aalejo]

1.- What version of CCM should I use to pass "Calling name" through a PRI QSIG H323 Gateway ?

2.- What version of 2651 IOS should I use?

3. What IE the gateway is using to pass the Calling Name?

4. What are the facilities that this configuration support?

[Chester Rieman]

1- 3.3(2c)

2- 12.2(15)T2

3- In the Setup IE

Cisco CallManager supports the following aspects of the QSIG protocol: QSIG basic call, direct dialing inward, certain supplementary services (name identification services), and certain QSIG generic functions services for support of supplementary services (call-related procedures for transport of application protocol data units and connection-oriented, call-independent application protocol data units). For information on whether your gateway supports the QSIG protocol, refer to the gateway product documentation.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_release_note09186a008011e2c8.html#1344646