05-20-2005 06:34 AM - edited 03-13-2019 09:10 AM
Hi all,
I've got and "old" TDM solution where two PBX's are connected across a satellite link using TDM's. This configuration is supposed to be moved to at 28xx based solution instead.
Do anyone have any sample config's on a direct pbx to pbx connection across a cisco network. I have no problems doing qsig at both ends, and then letting the routers do some routing based upon destination-patterns. But i would like the routers to stay as much out of the equation as possible.
unfortunately tie-lines is (as far as i know) not supported when running qsig on e1's.
Thanks in advance,
Lasse
05-25-2005 03:09 AM
05-26-2005 03:38 AM
Hi Dave,
I go through your configuration and I notice a configuration of overlaping ISDN. Why did you put direct-inward-dial command on the pots dial-peer ?
Mladen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide