route pattern resets PRI??

[markanthony]

I have an unusual problem. I am running CCM 4.0(2a)SR1 and a gateway router 2821 12.3.11XL.

I have a 2 port multiflex card which are MGCP controlled. Both of ports have a PRI connected and both work fine. My problem is that whenever I make a change to a routing pattern that uses the secondary port, it will reset that PRI. However if I make a change to a routing pattern that points to the first port it doesn't reset the port, just when I make changes on a routing pattern that points to the secondary PRI slot.

Any thoughts?

[#2]

Usually if you make a configuration change to a route pattern, and the route pattern gateway/route list box is pointing to the specific gateway port, a rest will reset the T1. If you point the route pattern to a route list, you should not have the same issues. Try this workaround: One route-group and route-list for 1st PRI, then same for 2nd PRI.