See faults in Startup config without COM cable

[vorapaip]

Hi, when I do larger configuration changes I like to do it directly into the config.text file and upload it after.
Then I connect directly via a COM cable to see if I did any mistakes, like forgetting to place "host" in an ACL etc, as it shows all faults in the text file during bootup.
Is there any way to see this without being directly connected?

[Roger Kallberg]

Have you done a sh log? Advise to do a term len 0 before you enter that command and make sure you have adequate buffer size to show all output or log the output to a file.