See which phone loads are held in RAM?

[schoeppner]

Hi,

The phoneloads for e.g. IP-phone 7960 are held in RAM in CCM 3.3(3). Can I unload the RAM to see which phoneloads were loaded from TFTP-service?

Or is the only possibility to change the TFTP-parameter "Build CNF Fildes" to "Build All"?

Thanks.

Heiko

[c-charlebois]

I'm not sure I understand the question. The Phoneload is the firmware. This will be whatever file is specified in the Phone Load field in the Phone Configuration, or if that is blank, whatever is specified in the Device Defaults. These are files stored on the CCM harddrive and not built and stored in RAM.

CNF files are built from the database and stored in memory. These contain configuration information about the phone and are loaded via TFTP whenever the phone resets. A clever way to see if a particular CNF file has been created is to use a TFTP client and request that file from the CCM. The filename is SEP.cnf.

[schoeppner]

Thanks for you reply and sorry for the confusion. I mean CNF files. I will try your tip quickly.