cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
505
Views
0
Helpful
1
Replies

Sending Fax problem

mirna_12345
Level 1
Level 1

Hi,

We have a netwrork RightFax and we are able to send Faxes to local numbers but not to an international number.

You can find below the configuration on the voice gateway and the output of " sh call history voice brief "

Kindly advice what does " Interworking 127 " mean and how can we solve this issue.

Could this problem be due to the E1 ?

Thanks in advance,

Mirna

2524 : 684972 08:53:41.660 UTC Wed Aug 29 2012.684902 +6760 +41050 pid:5 Answer

  dur 00:00:34 tx:1702/271286 rx:1333/319920 7F  (interworking (127))

  IP 172.16.164.180:56504 SRTP: off rtt:0ms pl:33240/100ms lost:1/1/0 delay:65/65/75ms g711ulaw TextRelay: off

   media inactive detected:n media contrl rcvd:n/a timestamp:n/a

   long duration call detected:n long dur callduration :n/a timestamp:n/a

2524 : 684973 08:53:41.978 UTC Wed Aug 29 2012.684904 +6440 +41190 pid:202 Originate 0096265652186

  dur 00:00:34 tx:1108/274784 rx:1702/271286 7F  (interworking (127))

  Telephony 0/0/0:0 (684973) [0/0/0.26] tx:34260/33920/0ms g711ulaw noise:-84dBm acom:51dBm

   long duration call detected:n long dur callduration :n/a timestamp:n/a

voice translation-rule 30
  rule 1 /^66/ /9/
!
!
voice translation-profile test-fax
  translate called 30
!

dial-peer voice 5 voip
  description outbound from fax
  translation-profile incoming test-fax
  destination-pattern 6666
  session target ipv4:172.16.37.121
  session transport udp
  incoming called-number 66.T
  voice-class codec 66  
  dtmf-relay h245-alphanumeric
  fax rate 14400
  fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none

dial-peer voice 202 pots
  corlist outgoing Partition-Block
  description ---- International via E1 Ogero
  translation-profile outgoing remove9
  destination-pattern 900T
  port 0/0/0:0
  forward-digits all

1 Reply 1

Bruno Rangel
Spotlight
Spotlight

Hi Mirna

Cause No.127: interworking, unspecified. This cause indicates there has been interworking with a network that does not provide causes for actions it takes; thus, the precise cause for a message being sent cannot be ascertained.

Please post your debug isdn q931 command output, with a failed call also post a with call that worked (Local)

Please rate this post

Cheers
Bruno Rangel
Please remember to rate helpful responses using the star bellow and identify helpful or correct answers
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: