cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

166
Views
4
Helpful
1
Replies
mikram
Enthusiast

Seperate E1 for inbound and outbound

Hi

I have two E1's from Provider and wants to use one for outgoing calls and another one for inbound calls. I am using MGCP gateway on 6608 blade.

any ideas?

thanks

1 REPLY 1
Chris Deren
Hall of Fame Master

The outbound side is controlled by CallManager, so simply include the Gateway you want to use for outbound calls in the route group, do not include the one for inbound calls. The inbound side is little trickier because that is controlled by the service provider, in most cases when you have multiple PRIs they are assigned to the sam,e Trunk Group so they can deliver calls to the same destination on either E1/T1. Contact your telco service provider and let them know that you do not want to receive inbound calls on this E1.

Rate all helpful posts!

Chris

Create
Recognize Your Peers
Content for Community-Ad