Sip Trunk between two different versions of CUCM

[Umer Javed]

Hy guys,

i want to know how to make sip trunk between two different versions of CUCM

actually i want to register DX650 with CM 8.6 and and want to make sip trunk with CM 10.5 so what should i do because there is no option in CM 8.6 for DX650 and what about the video feature of DX650 and as the difference of versions there is also difference of locations which is per-configured. i read the there location called shadow in CM 10.5 when we make sip trunk between two CM we Shadow location and its also not exist in CM 8.6

Thank you and Regards,

Umer Javed

[Ayodeji Okanlawon]

You add a sip trunk under device trunk..Then yu configure the ip address of the remote cluster under the destination address..

For you to use dx650 on cucm 8.6, you will need to install the latest device pack.

You can use enhanced location and this will automatically exchange location details between cucm clusters.