09-26-2006 05:07 PM - edited 03-13-2019 03:07 PM
I am in SRST mode and cannot gain access to the PRI.
I am able to dial to the numbes associated with the PRI
I have the following commands in the fallback config:
access-code pri 9 direct-inward-dial
secondary-dialtone 9
Dial-peer voice 20 pots
destination-pattern 9T
incoming called-number
direct-inward-dial
port x/x/x
Also, incoming calls work fine.
09-27-2006 02:25 PM
I suggest that you run the debug voice dialpeer command to see what's happening. I suspect you may need to have an outgoing profile associated with the dialpeer, that's what the debug indicated to me and when I created the profile I could then dial out in SRST mode for both PRI and BRI
Here's the relevant entries;
voice translation-rule 2
rule 1 /^1/ // type any unknown
voice translation-profile OutBound
translate called 2
dial-peer voice 11 pots
translate-profile outgoing OutBound
destination-pattern 1T
direct-inward-dial
preference 1
port 0/0/1
call-manager-fallback
transfer-pattern 1T
transfer-pattern 64..
secondary-dialtone 1
I don't have the access-code line on my config
Let me know if you still have no luck and I'll dump down the entire config for you to have a look at.
Good luck,
John
09-27-2006 06:32 PM
I will give it a try. Thanks for posting.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide