Stiver in Callmanager 3.3

[wrkemmer]

In CM 3.2 I could use C:\Sti\stiver.exe to get information on what OS version, service packs, etc. were installed. In CM 3.32 there is no Sti folder, so it appears that this utility is gone. How do I get this information in 3.32?

Thank you.

[shrenikk]

You could use c:\utils\mcsver.exe instead.

[dgoodwin]

Just an additional note here:

Any server that was installed fresh using the OS CDs version 2000.2.4 or later will have ONLY the utility located at C:\Utils\MCSVer.exe

Any server that was installed fresh using the OS CDs anything earlier than the above, and then later upgraded to 2000.2.4 will have C:\Utils\MCSVer.exe and also C:\STI\STIVER.exe.

Both utilities are valid. Just keep in mind you should start remembering to use MCSVer.exe all the time for servers running 2000.2.4 or later.